How to solve deformation EPS foam products after demolding?

How to solve deformation EPS foam products after demolding?

Issues such as expansion or deformation in the manufacturing of EPS molded foam products can be caused by short maturation time, improper pre-expanding methods, high steam heating pressure, and high material density. Solutions include extending maturation time, adjusting pre-expanding methods, lowering steam heating pressure, and using EPS material of suitable density.

Suit for EPS machine

Description

During the process of manufacturing EPS molded foam products, issues such as expansion or deformation may occur. These problems are usually caused by a variety of factors, including but not limited to, the short maturation time of EPS bean, improper selection of pre-expander methods, excessively high steam heating pressure, and overly high material density, etc. Below is a detailed introduction to these problems and corresponding improvement measures.

  1. Short maturation time or aging time leads to incomplete expanded of EPS foam productsThe length of the maturation time directly affects whether the EPS foam can fully foam, thereby affecting the quality of the product. If it is found that the short maturation time leads to incomplete expanded of the EPS foam product, we can improve it through the following solutions:
    • Extend the maturation time to ensure that the EPS foam is fully expanded and reaches the required stable state. This can make the EPS foam product more stable, thereby improving its quality.
  2. Improper pre-expanding methodThe choice of pre-expanding method also affects the quality of EPS foam products. If it is found that the pre-expanding method is improper, we can improve it through the following solutions:
    • Adjust the pre-expanding method of the pre-expanding to ensure that there is enough interval between the expanding processes, usually around 4 hours, to ensure the completeness of the expanding process. This practice can make the expanding of the EPS foam product more even, thereby improving its quality.
  3. The steam heating pressure is too highThe level of steam heating pressure affects the foaming speed of EPS foam products. If it is found that the steam heating pressure is too high, we can improve it through the following solutions:
    • Lower the steam heating pressure to slow down the foaming speed and prevent the foam product from over-expanding or deforming. This can make the shape of the EPS foam product more regular, thereby improving its quality.
  4. High density causes the material structure to be tight and difficult to expand or deform.The density of EPS material affects its ability to expand or deform. If it is found that the high density causes the material structure to be tight and difficult to expand or deform, we can improve it through the following solutions:
    • Replace with EPS material of suitable density to ensure that the product has the required expansion performance while meeting usage requirements. This can make the EPS foam product more suitable for its use environment, thereby improving its quality.

Photo

How to solve deformation EPS foam products after demolding
How to solve deformation EPS foam products after demolding

Leave a Message