Compressed air requirements for EPS thermoforming machine

Compressed air requirements for EPS thermoforming machine

This page provides information about the compressed air requirements for an EPS thermoforming machine.

Suit for EPS machine

Description

Compressed air intake pipe diameter: greater than DN25

Normal operating pressure of the machine: stable pressure greater than 7 kg.

Compressed air requirements for EPS thermoforming machine

As shown in the picture, the knob below the filter is used to adjust the pressure of the compressed air intake.

Compressed air requirements for EPS thermoforming machine

The pressure of the atomized water cooling spray gun can be adjusted separately behind the filter, and the recommended pressure range is 5-6 kilograms.

The pressure gauge for water cooling is located on the right side of the pressure regulator, and the specific water cooling pressure needs to be determined based on the spraying time and the atomization cooling effect.

Compressed air requirements for EPS thermoforming machine
Compressed air requirements for EPS thermoforming machine

Video

Leave a Message